Police Bltiz On Wellington RD CNR Stud RD

This is a general discussion forum, open to all participants
Post Reply
effaircon
Cruising
Posts: 481
Joined: June 20th, 2008, 8:52 pm
Location: Boronia vic

Police Bltiz On Wellington RD CNR Stud RD

Post by effaircon »

Has anyone else been through the blitz tonight. Task Force have been there since 7PM and are still there now.
I got a major and EPA'D 13DB over the limit i reckon a good few hundred cars would have got done they blocked 3 lanes down to one and were pulling cars into a factory carpark. The cop said this was one of many they were going to be doing, and the biggest bust the have ever had in the eastern suburbs.

cheers corey
1994 ED FAIRMONT: 3:45:1 Diff Gears and LSD, Clive Cams 605 Billet, Crow Double Valve Springs, Rollmaster Vernier Gear, Medium Ported & Polished EL Head, AU Steel Head Gasket, Pacemaker 4499's, XH Snorkel, K&N Filter, Custom 3" Air Intake, EL Thermos 2 1/2 Cat Back Exhaust, Smoothed Black Rocker Cover, Turbo Blades, Chopped Rears Standard Fronts, J3 Chip & EL ECU Untuned Atm
User avatar
Malakai
Double Clutching
Posts: 5251
Joined: July 21st, 2007, 1:23 pm
Location: Brisbane
Contact:

Re: Police Bltiz On Wellington RD CNR Stud RD

Post by Malakai »

Oh shit run, it's the cops!
FG G6E Turbo MkII - Nizpro Stage 3 - 364 rwkW - 11.63 sec @ 118 mp/h | I like the dark, I love the dark, but I hate nature. Image
User avatar
rhys
Full Boost
Posts: 2040
Joined: April 4th, 2008, 7:34 pm
Location: Upper Gully, Vic

Re: Police Bltiz On Wellington RD CNR Stud RD

Post by rhys »

fark, will have to be careful tomoz night. compared with most other falcon/commonwhores on the road, how loud would you rate you car? I have no idea if im over the limit and if so by how far.
1990 Toyota 4Runner SR5 - 5 spd manual - 33" mud tyres - BBQ gas - Slower than your nannas corolla - Goes anywhere you point it

AU Falcon - Sold
Tickford 4L - Pod - XR6 Turbo snorkel - Custom Stainless Intake - SS Inductions T/B - Ph4480's - 3" 200CPSI Hi flow cat - Custom Exhaust - T5 - Exedy HD clutch - SVI LPG - Premium sound - T3 TE50 kit - Bollé Tint - Full XR8 interior
User avatar
Bomber
Full Boost
Posts: 2275
Joined: July 16th, 2007, 11:28 am
Location: Narre Warren South
Contact:

Re: Police Bltiz On Wellington RD CNR Stud RD

Post by Bomber »

rhys375 wrote:fark, will have to be careful tomoz night. compared with most other falcon/commonwhores on the road, how loud would you rate you car? I have no idea if im over the limit and if so by how far.
lol AU would have to be around 130DB if not more
My Rides
2000 AUII Fairmont Wagon - 1999 AU XR6 6 speed < Click for build thread.
Image
User avatar
Phillis
Breaking Traction
Posts: 1863
Joined: August 10th, 2008, 3:37 pm
Location: Croydon, Melbourne

Re: Police Bltiz On Wellington RD CNR Stud RD

Post by Phillis »

fkn pigs should all go die. We run dese streetz
'94 EF XR6 Wagon- Build Thread here
pHaT`eL wrote:Editing posts never really gets old :)

I have a tiny tiny penis.
effaircon
Cruising
Posts: 481
Joined: June 20th, 2008, 8:52 pm
Location: Boronia vic

Re: Police Bltiz On Wellington RD CNR Stud RD

Post by effaircon »

rhys375 wrote:fark, will have to be careful tomoz night. compared with most other falcon/commonwhores on the road, how loud would you rate you car? I have no idea if im over the limit and if so by how far.
Well as we know the legal limit is 90DB throughout the rev range and mine was 88-89DB at idle and peaked at 105DB.
My car was pretty loud.

cheers corey
1994 ED FAIRMONT: 3:45:1 Diff Gears and LSD, Clive Cams 605 Billet, Crow Double Valve Springs, Rollmaster Vernier Gear, Medium Ported & Polished EL Head, AU Steel Head Gasket, Pacemaker 4499's, XH Snorkel, K&N Filter, Custom 3" Air Intake, EL Thermos 2 1/2 Cat Back Exhaust, Smoothed Black Rocker Cover, Turbo Blades, Chopped Rears Standard Fronts, J3 Chip & EL ECU Untuned Atm
User avatar
UNEZED
Breaking Traction
Posts: 1288
Joined: August 14th, 2007, 12:31 am
Location: BOOBIES

Re: Police Bltiz On Wellington RD CNR Stud RD

Post by UNEZED »

i seen a few cops between sandown and noble maccas so i just went around n bak up the hwy
Image
UNEZED - R.I.P it had its fun
SLMDXR ELXR8 - R.I.P
'09 FG XR8 Stocker but still goes alrite
RATTLA 95 EF Fairmont gone
96 EL Fairmont Ghia 5LT
06 BF XR6
User avatar
Barnsy
Spooling Up
Posts: 886
Joined: July 19th, 2007, 10:29 pm
Location: Geelong

Re: Police Bltiz On Wellington RD CNR Stud RD

Post by Barnsy »

FYI
www.airpowersystems.com wrote:
Exhaust Noise Testing
Many statutory bodies around the world currently mandate that vehicles comply with stationary exhaust noise tests specifications - Generally based upon the "SAE J1169 Measurement of Light Vehicle Exhaust Sound Level under Stationary Conditions"

In Australia the test requirements are ADR 28/01 stationary noise test and based upon SAE J1169. In fact, the above tests have identical test procedures and only the required limit varies:
SAE J1169 USA 95 dB
ADR 28/01 Australia 90 dB

The test involves positioning a type 1, SIA compliant ANSI S1.4 - 1983 noise level meter, specifically as illustrated in the diagram below. No other positioning is relevant! Noise tests are extremely specific in their scope and must be conducted very carefully!

Image
Diagram from SAEJ1169 Testing Procedures

Engine RPM must be held steady at 75% of rated peak horsepower RPM.

Given the latter figure is 5,200 RPM for the XR6T, the test engine speed is 3,900 RPM for these vehicles.

Again, it must be emphasised, all facets of a noise test must be specifically followed for the test to have any meaning.
The Old: 1993 ED Fairmont, 1994 ED Futura Classic Manual, 2004 BA MkII XR6 Turbo, 2009 G6E Turbo, 2007 Audi S5 V8 Manual

The New: 2015 Territory Titanium Petrol RWD
User avatar
iliov
Cruising
Posts: 445
Joined: June 6th, 2008, 8:37 pm
Location: SE Melbourne

Re: Police Bltiz On Wellington RD CNR Stud RD

Post by iliov »

LOL, that was a fuken shit setup. I was comming down the hill on wellington rd going from mulgrave country club to stud park. Saw flashing lights from the top of the hill so I made a left just before the golf course and went around and down FTG road where not a single cop was seen. I also went home down wellington road the other way and saw all the EPA cars. Rather funny how easy it was to avoid.....
Image
effaircon
Cruising
Posts: 481
Joined: June 20th, 2008, 8:52 pm
Location: Boronia vic

Re: Police Bltiz On Wellington RD CNR Stud RD

Post by effaircon »

Barnsy wrote:FYI
www.airpowersystems.com wrote:
Exhaust Noise Testing
Many statutory bodies around the world currently mandate that vehicles comply with stationary exhaust noise tests specifications - Generally based upon the "SAE J1169 Measurement of Light Vehicle Exhaust Sound Level under Stationary Conditions"

In Australia the test requirements are ADR 28/01 stationary noise test and based upon SAE J1169. In fact, the above tests have identical test procedures and only the required limit varies:
SAE J1169 USA 95 dB
ADR 28/01 Australia 90 dB

The test involves positioning a type 1, SIA compliant ANSI S1.4 - 1983 noise level meter, specifically as illustrated in the diagram below. No other positioning is relevant! Noise tests are extremely specific in their scope and must be conducted very carefully!

Image
Diagram from SAEJ1169 Testing Procedures

Engine RPM must be held steady at 75% of rated peak horsepower RPM.

Given the latter figure is 5,200 RPM for the XR6T, the test engine speed is 3,900 RPM for these vehicles.

Again, it must be emphasised, all facets of a noise test must be specifically followed for the test to have any meaning.
yeh thats exactly how they did it.

cheers corey
1994 ED FAIRMONT: 3:45:1 Diff Gears and LSD, Clive Cams 605 Billet, Crow Double Valve Springs, Rollmaster Vernier Gear, Medium Ported & Polished EL Head, AU Steel Head Gasket, Pacemaker 4499's, XH Snorkel, K&N Filter, Custom 3" Air Intake, EL Thermos 2 1/2 Cat Back Exhaust, Smoothed Black Rocker Cover, Turbo Blades, Chopped Rears Standard Fronts, J3 Chip & EL ECU Untuned Atm
User avatar
LOW_XR
Hitting N2O
Posts: 3009
Joined: October 7th, 2007, 6:13 pm
Location: boronia

Re: Police Bltiz On Wellington RD CNR Stud RD

Post by LOW_XR »

shit, lucky. i was thinking of hitting the hwy last night at bout 11.30.
lucky i didnt cos i would go via stud road :o
CHRYSLER 300c SRT-8

6.1 LT HEMI
Procharger + intercooler
MagnaFlow stainless Exhaust
debadged
Black leather
4 pot brembos all round
20" wheels
sunroof
tint
touch screen dvd player , sat nav, ipod etc etc
chrome grip grille
+ more
turbo
Idling
Posts: 80
Joined: June 3rd, 2009, 5:23 am

Re: Police Bltiz On Wellington RD CNR Stud RD

Post by turbo »

last 3 days cops down edithvale road drug bus and sht there last night
User avatar
pHaT`eL
Moderator
Moderator
Posts: 8060
Joined: July 16th, 2007, 2:12 pm
Location: Cruise Moderator

Re: Police Bltiz On Wellington RD CNR Stud RD

Post by pHaT`eL »

I woulda been fucked for noise, lol.. Glad I didnt go out :P
[XGZ-566] 2009 BF3 XT EGAS WAGON
| 19x9 & 19X10 WORK EUROLINE'S | LOWERED |

[MR-PGR] 1980 XD FAIRMONT WAGON
| EFI WINDSOR | 14X8 & 14X10 12 SLOTTER'S | VENETIANS |

PREVIOUS RIDES: [WANTD-6] 2002 AU3 EGAS FORTE WAGON | [POPS4L] 1995 EF GLi WAGON | [EBW-302] 1991 EB GL WAGON V8 | [PHATEL] 1998 EL FAIRMONT TURBO

phat GUARD ROLLING | 0429 093 302 | facebook
User avatar
XR_Lightning
Hitting N2O
Posts: 3716
Joined: July 23rd, 2007, 6:48 pm
Location: Dandenong North

Re: Police Bltiz On Wellington RD CNR Stud RD

Post by XR_Lightning »

pHaT`eL wrote:I woulda been fucked for noise, lol.. Glad I didnt go out :P
your cars not that loud anyway, would of passed easy, lol :D
ED XR6 - T5 - 1521a@112 - 3.9's - 170.2rwkw - POWERED BY METALLICA
User avatar
glenneaux
Spooling Up
Posts: 832
Joined: July 26th, 2007, 6:23 pm

Re: Police Bltiz On Wellington RD CNR Stud RD

Post by glenneaux »

turbo wrote:last 3 days cops down edithvale road drug bus and sht there last night
A while ago i rolled through there in the supra.. they were okay though, didnt look twice at the car..
JZA80 Supra
2JZGTE, Getrag 6spd, TRD 320km/h speedo, TRD 10k rpm tacho, TRD fuel/water temp gauge.
HKS T51R SPL, GReddy Massive cooler, 5" Turbo Back exhaust, Motec M800, Titan 3.4L Stroker, Cusco triple plate clutch.
Post Reply